Can you mount a transom mount transducer in hull?

This transducer can be mounted on the transom of the boat or bonded to the inside of a fiberglass hull boat with a two part slow curing epoxy. The transom installation, which is the most widely used, places the transducer on the outside of the boat hull.

Where does the thru-hull transducer go?

Transducer placement should be aft and close to the centerline. It needs to be located low enough that the transducer is in the water at all times. Consider items such as the lifting strap placement into the location as well as trailer bunks and rollers if it is a trailered vessel.

What is a through hull transducer?

Thru-hull transducers. This transducer mounts flush to the bottom of the boat and has a tilted element in it’s housing to compensate for your boat’s deadrise. The most common thru-hull transducers utilize bronze housings that work with fiberglass, wood and other hull materials.

What do I need to install an in Hull transducer?

An in-hull transducer installation is bonded to the inside of the hull with epoxy and will typically consist of a container filled with propylene glycol. When installing an in-hull mounted transducer, it is essential to carefully follow the installation instructions provided within each transducer kit.

What’s the best way to mount a transducer?

Place the transducer inside a thin plastic bag partially filled with water and cinched tightly with a cable tie. Wet the mounting surface and press the active face of the transducer against the hull. Compare the bottom return to the baseline, and if the reading is similar, the mounting location is good.

How to install a transducer on a West Marine Boat?

Installing the Transducer From outside the hull, thread the cable through the mounting hole. Then push the stem of the transducer through the hole… From inside the hull, slide the backing block (if installing with a fairing) and the hull nut onto the cable. Seat any… Remove any excess marine

How is a sidevu thru hull transducer installed?

SideVu Thru-Hull transducers are installed similarly to a single thru-hull with the exception that a second thru-hull is on the opposite side of the vessel. There is a cable to connects the pair of transducers, and then a single cable is plugged into the chartplotter.

Can you mount a transom mount transducer in hull? This transducer can be mounted on the transom of the boat or bonded to the inside of a fiberglass hull boat with a two part slow curing epoxy. The transom installation, which is the most widely used, places the transducer on the outside of the boat…