What causes P2009 code?

The P2009 error code would mean that the intake manifold runner control circuit has excessively low voltage for bank 1. This diagnostic fault code is a generic powertrain code, which means that it would apply to the OBD-II equipped vehicles.

Can I drive with P2009?

How serious is the P2009 code? The P2009 code will not prevent the vehicle from driving to a safe location once the code has been triggered. As with any code it should be repaired as soon as possible for normal vehicle operation.

Where is the intake manifold runner position sensor Bank 1?

What does OBD-II fault code P2015 mean? Code P2015 stands for Intake Manifold Runner Position Sensor Range Bank 1. The intake manifold sits on top of the engine between the cylinder heads.

What does the p2009 OBD-II trouble code mean?

This code is similar to P2005, P2006, P2007, P2008, P2010, P2013 and P2015. P2009 means the intake manifold runner control circuit has excessively low voltage for bank 1. Once the ECU figures out that low voltage is present in the intake manifold runner control circuit a Check Engine Light will be triggered.

What does the p2009 code on an ECU mean?

What the P2009 code means. P2009 means the intake manifold runner control circuit has excessively low voltage for bank 1. Once the ECU figures out that low voltage is present in the intake manifold runner control circuit a Check Engine Light will be triggered.

What does p2009 stand for in PCM?

Although generic, the specific repair steps may vary depending on make/model. I know from experience that a stored code P2009, means that the powertrain control module (PCM) has detected an intake manifold air control (IMRC) actuator circuit voltage (for engine bank one) that is lower than expected.

Why do I have a p2009 code on my solenoid?

Nonetheless, it should be noted that while code P2009 is mostly concerned with electrical low circuits in the actuators’ control circuit, vacuum leaks can also cause this code on some applications, since under these conditions the runner flaps’ position sensor can produce a signal that does not agree with the runner flaps’ desired position.

What causes P2009 code? The P2009 error code would mean that the intake manifold runner control circuit has excessively low voltage for bank 1. This diagnostic fault code is a generic powertrain code, which means that it would apply to the OBD-II equipped vehicles. Can I drive with P2009? How serious is the P2009 code?…