How long does it take to remove and replace a fuel pump?

Any car with an external fuel pump is going to be easier and sometimes will take less than an hour. However, if you’re replacing the entire fuel assembly and need to drop the fuel tank, things can get more complicated. On average, this will take somewhere between 2-3 hours.

Where is the fuel pump located on a 2004 Chevy Impala?

The 2004Chevrolet Impala has a fuel pump relay that can be found in the main fuse box. This box is located at the front of the engine compartment. To find it, You will first need to go to the front of Your truck, and open the hood.

How much does a fuel pump cost for a 2003 Chevy Impala?

Chevrolet Impala Fuel Pump Replacement Cost Estimate. Labor costs are estimated between $213 and $268 while parts are priced between $602 and $769.

Where is the fuel filter on a 2003 Chevy Impala?

How to Install a Fuel Filter in a 2003 Chevy Impala

Open the hood for access to the fuse panel.
Open the fuse panel by hand and locate the fuel pump relay.
Start the car and allow it to idle until it stalls.
Locate the fuel filter under the car in front of the rear wheel.

How much is a fuel pump replacement?

How Much Does Fuel Pump Replacement Cost? The average cost for a fuel pump replacement is between $220 and $1,062 depending on vehicle and age. Labor costs are estimated between $124 and $260, while parts are priced between $95 and $854.

Can you replace the fuel pump in a 2003 Chevy Impala?

The fuel pump in your 2003 Chevrolet Impala is easy to access. Unlike on many vehicles, you will not have to remove the fuel tank or jack up the car. All of the connections are designed to be separated by hand, so you only need tools to remove an access panel. A replacement pump can be purchased or ordered from most auto-part shops.

How do you remove the fuel pump access panel?

Remove the spare tire and trunk liner to reveal the fuel pump access panel. Remove the seven nuts that hold it in place and pull off the panel. Unplug the electrical connector and wipe off the pipes and assembly to prevent buildup from getting into the fuel. Snap open the quick-connect fittings and remove the hoses.

What to do if your fuel pump is dead?

Pull the fuel pump relay out of the junction box on the right side of the engine compartment. The inside of the lid shows the location of the relay. Start the car and run it until the engine dies. If your fuel pump is completely dead and the engine won’t run, then the pressure is already relieved from those lines.

Where can I get a new fuel pump?

A replacement pump can be purchased or ordered from most auto-part shops. Relieve the fuel system pressure. Open the gas filler cap. Pull the fuel pump relay out of the junction box on the right side of the engine compartment. The inside of the lid shows the location of the relay. Start the car and run it until the engine dies.

https://www.youtube.com/watch?v=UE5PTiL46rs

How long does it take to remove and replace a fuel pump? Any car with an external fuel pump is going to be easier and sometimes will take less than an hour. However, if you’re replacing the entire fuel assembly and need to drop the fuel tank, things can get more complicated. On average, this…