How do I reset my radio in my Ram 1500?

The 2018 Dodge 1500s radio can be reset by pushing and holding down the volume button, as well as the tuner button for approximately 10-15 seconds. When the radio has started resetting, its screen should go black. After a few seconds, restart the radio to see if it has successfully been reset.

What is the IOD fuse on a Dodge Ram?

This IOD or “Ignition Off Draw” fuse is used during assembly line work, and when vehicles are in storage on dealer lots to prevent battery going dead. It is recommended if vehicle sits unused for a period of time, say for more than 10 days or so, that you pull it to shut off parasitic drain to the battery.

How do you reset the ECM on a Dodge Ram?

To turn it off, you’ll need to reset the computer….Turning Off the RAM 1500 Check Engine Light

Identify your battery’s negative cable.
Disconnect the negative cable from the battery.
Wait 20 minutes so that all systems have shut down.
Reconnect the negative cable.

How do you reset the radio on a 2013 Dodge Ram 1500?

To perform a 2013 Dodge Ram 1500 radio reset, hold down the temp up and down buttons for 5 seconds and then select radio reset. You will come into problems with the sound. This could be from the stereo’s speakers or a phone that is connected to the vehicle.

What does the ignition off draw fuse do?

The ignition Off Draw (IOD) fuse is used to prevent battery discharge during shipping or long-term storage of the vehicle. When the IOD fuse holder is depressed into the carrier, an initial distinct detent will be felt to overcome the “pre-hold” position.

Is there a fuse for Uconnect?

It’s in the fuse box under the hood and is 15 amps. You could always disconnect the battery.

Where is the Uconnect fuse located?

Registered. On our 2012, the radio fuse is located in the fuse box under hood, above the driver’s side front wheel.

Is there a fuse for the ECM?

The ECM 1 is one such computer; it has a fuse is installed to protect the computer from sudden power surges or other component damage — the fuse will blow before any damage can reach the ECM. Many component defects can cause your ECM 1 fuse to blow.

What should I do if my Dodge Ram Radio is not working?

Dodge Ram radio not working. IOD fuse and wire repair. Interior Lights, & Keyless Entry fix – YouTube Solved! Dodge Ram radio not working. IOD fuse and wire repair.

What kind of radio does a Dodge Ram 1500 have?

I have a 2003 Ram 1500 Quad Cab with the standard OEM single CD radio system. The problem I have is that on a warm day the radio gives me an Err message when first powered up.

Why is my Dodge Ram 1500 not working?

See all problems of the 2013 Dodge Ram 1500 . When you copy mp3’s to the hard drive and then play them the radio will lock up and not function till you shut the car off for 90seconds I have had the radio replaced and it still does the same thing I have a 2013 durango that does the exact same thing. This is a software bug in the radio.

Why does my CD player not work in my Dodge Ram?

It also makes a noise that sounds like it is attempting to eject a CD when there is no CD in the system, this sound happens sometimes while the radio is on and almost every time the radio is turned off this continues to happen for a up to a minute. It then stops, other than that the radio and CD player do work fine.

How do I reset my radio in my Ram 1500? The 2018 Dodge 1500s radio can be reset by pushing and holding down the volume button, as well as the tuner button for approximately 10-15 seconds. When the radio has started resetting, its screen should go black. After a few seconds, restart the radio to…