How do you make a 2 liter tornado?

How do you make a 2 liter tornado?

Instructions:

  1. Fill your container about ¾ full with clean water.
  2. Add a squirt of dish soap, as well as your glitter or food coloring, if desired.
  3. Seal the container tightly.
  4. Move the bottle rapidly in a circular motion. After a few seconds, you should see the water begin swirling. Stop, and watch your tornado!

How do you make a tornado tube connector?

  1. Fill one soda bottle about two-thirds full of water.
  2. Place the washer on top of the soda bottle.
  3. Put the empty soda bottle on top of the washer. You might want a second person to hold it stationary.
  4. Bind the bottles together with electrical tape.
  5. Shake the bottle gently to make sure there are no leaks. Tip.

What is a tornado tube connector?

Tornado Tubes Bulk Pack of 120 Show that in order for water to flow down, air must flow up. These amazing connectors screw onto two plastic soda bottles (you can buy new ones from E.I., Item number BOT-600 and allow students and teachers to create a water vortex.

How do you hook up a 2 liter bottle?

Wrap the area around the mouths of the bottle with duct tape. Work slowly and press the tape against the plastic bottles to form a tight seal. Tilt the bottle contraption on its side so that some of the water is at the mouths of both bottles. Slowly rotate the contraption and check for leaks.

How do you make a tornado in duct tape bottle?

Fill one of the bottles two-thirds full of water. Take the Tornado Tube and twist it on the first bottle. Then, grab the second bottle and attach it to the Tornado Tube. Or use duct tape to fasten the two containers.

How does a tornado tube work?

A tornado tube is a fun toy which allows you to create a mini-tornado. You connect two pop bottles together. You then move the top bottle around in small quick circles, for a few seconds, and what happens next is that the water forms a vortex in which the water spirals down into the bottom bottle. …

How do you use a tornado maker?

What To Do

  1. Fill one of the bottles 2/3 full of water. Add glitter and food colouring.
  2. Place the washer on the top of the bottle.
  3. Place the second (empty) bottle upside down above the first (filled bottle). Carefully line up the two mouths and tape them together using duct tape, taking care to create a water tight seal.

What is a vortex connector?

The Vortex Bottle Connector is a plastic adapter fitted so that two plastic soda bottles can be held together in order to create a vortex in the top bottle. It works by flipping and then spinning the top bottle so that air begins to replace the water in the top bottle, forming a vortex shape.

How do you make a 2 liter tornado? Instructions: Fill your container about ¾ full with clean water. Add a squirt of dish soap, as well as your glitter or food coloring, if desired. Seal the container tightly. Move the bottle rapidly in a circular motion. After a few seconds, you should see the water…