How do you make a water level in a controller circuit?

To make this circuit you will need

BC 547 Transistor X 3 = 9 INR.
220 K Ohm & 5.4 K Ohm resistors = 1.
1N4007 Diode = 1.
12V relay = 12.
One, 3-pin PCD connector & two, 2-Pin PCB connector = 25.
Wires = 5.
PCB = 12.

What is a water level controller?

A water level controller is a device that manages water levels on a variety of systems such as water tanks, pumps and swimming pools. The basic function of a water level controller is to regulate water flow and optimize system performance.

What is the working principle of water level indicator?

Principle of Water Level Indicator. The working principle of a water level indicator is actually quite simple. Water level indicators work by using sensor probes to indicate water levels in a storage tank. These probes send information back to the control panel to trigger an alarm or indicator.

How does the 8051 microcontroller control the water level?

Below I am mentioning a small code for 8051 microcontroller which controls the water level and blinks the led as per the water level in the tank. The water level controller using 8051 microcontroller automatically switches ON the motor whenever the tank is empty and switches OFF the motor whenever the tank is full. 8051 Microcontroller.

How to design circuit for water level controller?

Again, the motor runs when water level in the tank becomes LOW. How to Design Circuit for Water Level Controller using 8051 Microcontroller? The heart of the Water Level Controller using 8051 Microcontroller project is the AT89C51 Microcontroller.

How does a water level controller work on a sump tank?

The level of the over head tank is indicated using 5 LED’s and the pump is switched OFF when the over head tank is full. The pump is not allowed to start if the water level in the sump tank is low and also the pump is switched OFF when the level inside the sump tank goes low during a pumping cycle.

How does the water level monitor system work?

The status of water level in the tank and status of the motor is displayed using an LCD module. This system monitors the water level of the tank and automatically switches ON the motor whenever tank is empty. The motor is switched OFF when the overhead tank or container is FULL.

How do you make a water level in a controller circuit? To make this circuit you will need BC 547 Transistor X 3 = 9 INR. 220 K Ohm & 5.4 K Ohm resistors = 1. 1N4007 Diode = 1. 12V relay = 12. One, 3-pin PCD connector & two, 2-Pin PCB connector = 25.…