How do you remove a differential carrier bearing without a press?

How to Change a Carrier Bearing Without a Press

Cut the bearing cage with the cutoff tool. Remove all the bearings and the cage.
Place the chisel in the groove made by the cutoff tool, and strike it with the large hammer to break the inner race.
Place the opposite end of the carrier on the two-by-four block of wood.

Can you drive with a bad carrier bearing?

A failed bearing will not be able to properly support the drive shaft, and as a result the drive shaft will flex incorrectly, which will cause vibration and shuddering. A worn center support bearing will not be able to properly support the vehicle and will render it undrivable once it completely fails.

How much does it cost to replace pinion bearing?

Pinion Seal Replacement Cost – RepairPal Estimate. Labor costs are estimated between $170 and $214 while parts are priced between $60 and $62. This range does not include taxes and fees, and does not factor in your specific vehicle or unique location.

How much does it cost to replace carrier bearing?

The average cost for a Carrier Bearing Replacement is between $287 and $370 but can vary from car to car.

Where are the bearings in a GM differential?

Two bearings are in the axle ends, two are in the differential carrier bearings, and two are in the pinion bearings. Worn bearings or improper gear adjustments most often create these noises. Keep in mind that worn-out U-joints in the driveline can also cause clunking sounds; inspect those first to eliminate that possibility.

How to remove pinion seal from Chevy differential?

Pinion Yoke Removal 1 Remove Pinion Nut A fair amount of torque is required for removing the pinion nut. 2 Remove Yoke A few blows with a soft hammer usually gets the yoke free from the splines. 3 Remove Pinion Seal (Special Tool)

What’s the best way to disassemble a Chevy differential?

The first step is to use a socket and ratchet or a wrench to remove the cover bolts. Use a soft mallet to break the seal or use a pry bar, but be careful not to damage the mounting surface of the center section. Place a drain pan under the center section, and once the cover has been removed, allow the fluid to drain.

How does the pinion gear work on a GM differential?

In both units the pinion gear uses a crush sleeve to set the preload on the bearings and removing it requires the installation of a new crush sleeve. So, consider this fair warning. Once the axle shafts have been removed, you can lift the ring gear and carrier out of the center section. Then the carrier disassembly can commence.

How do you remove a differential carrier bearing without a press? How to Change a Carrier Bearing Without a Press Cut the bearing cage with the cutoff tool. Remove all the bearings and the cage. Place the chisel in the groove made by the cutoff tool, and strike it with the large hammer to break…