How do you reset the PASSLock system?

How do you reset the PASSLock system?

Thankfully this is an easy fix.

1. Leave the ignition key turned to the “On” position after the vehicle has stalled and will not start.
2. Look at the dashboard and locate the theft system light.
3. Turn the ignition to the “Off” position to disable the PassLock system, and wait for 20 seconds for the system to reset.

How do you relearn a Chevy key?

GM VATs Relearn

1. Insert a master key (black head) into the ignition switch.
2. Turn key to the “ON” position without starting the engine.
3. Wait for 10 minutes or until the security light turns off.
4. Turn key to the “OFF” position for 5 seconds.
5. Turn key to the “ON” position without starting the engine.

How do you reset theft deterrent?

Close the door and wait for the security light to stop flashing from inside the car. Another option is to close the doors first, and then press the “Lock” button on the keyless remote. This will also pre-arm the theft-deterrent alarm system.

How do I reset my GM theft deterrent?

How to Reset a GM Theft Deterrent

1. Use your GM keyless remote to unlock the doors by pressing the “Unlock” button. This button looks like an opened lock.
2. Exit the car and leave the door open.
3. Close the door and wait for the security light to stop flashing from inside the car.

How do you reset a chevy theft deterrent?

The anti-theft is now reset. In a chevy silverado, you will try to reset the anti-theft system by turning the key on until the yellow lock goes out on the instrument panel for about 10 minutes. Turn the key off and do it 2 more times after 3 cycles, pull the key and put it back in.

How do you bypass a passlock?

PASSLOCK-II bypass procedure 1: Locate two wires, which are THIN and are in the main ignition harness.. Orange/Black (or Black) and Yellow. 2: Cut the Yellow wire, and strip back some of the insulation from the Orange/Black (Or Black) wires. 3: Turn the ignition to the “Run” position ( don’t crank the starter).

How does a PassLock system relearn procedure work?

If the IPC/BCM receives the expected coded signal, the IPC/BCM will send a message over serial data to inform the PCM that the vehicle may be started. To perform a relearn on a Passlock system, make sure there is a fully charged battery in the vehicle.

What’s the highest failure rate of PassLock systems?

PassLock seems to have the highest failure rate. So if you have a key WITHOUT a chip in it, chances are it’s a PassLock system. This article describes how to troublshoot and fix a PassLock system. But here are some more articles to help Passlock Reset procedure. Reset security system on chevy, buick, oldsmobile, cadillac, pontiac, saturn, hummer.

How long does it take to reset PassLock on Chevy?

Passlock Reset procedure. Reset security system on chevy, buick, oldsmobile, cadillac, pontiac, saturn, hummer. Make sure the battery if fully charged because this procedure may take up to 30 minutes and you cannot start the vehicle during this time.

How long does it take to relearn a security key?

Additional keys may be relearned immediately after the first key has been learned by inserting the additional key and turning the ignition switch to on within 10 seconds of removing the previously learned key. Turn key to the “ON” position without starting the engine. Security light should turn on and stay on.

How do you reset the PASSLock system? Thankfully this is an easy fix. Leave the ignition key turned to the “On” position after the vehicle has stalled and will not start. Look at the dashboard and locate the theft system light. Turn the ignition to the “Off” position to disable the PassLock system, and wait…