What are the parts of a Solex carburetor?
What are the parts of a Solex carburetor?
Solex carburetor is a down draught type carburetor. It consists of the devices for starting, idling normal running and acceleration. These are described in brief as follows. The figure shows a starting device for Solex carburetor. It consists of a starter valve in the form of a flat disc having holes of different sizes.
When to put seat valve on Solex h 30 / 31?
To set it up initially, I line up the marks on the housing and the top of the carb in the middle of the marks. You will end up tweaking it in the winter and then again in the summer. Time to flip the top over and install the needle and seat valve.
How to rebuild a Solex h 30 / 31 carb?
To set it up initially, I line up the marks on the housing and the top of the carb in the middle of the marks. You will end up tweaking it in the winter and then again in the summer. Time to flip the top over and install the needle and seat valve. Make sure you follow the instructions in the rebuild kit so you get the right washer in.
What kind of lock washer do I need for Solex?
4. Use two 8mm thread (13mm hex) nuts along with two 8mm ID flexible lock washers (also called “wavy” lock washers). 5. Carefully tighten the hex nuts, alternating back and forth between each nut to equally torque the Carburetor base down to the flange to prevent the Carburetor Base and the mounting flange from warping.
Where is the accelerator cable on a VW Solex?
6. Connect the Accelerator Cable at the Barrel Nut Assembly in the Throttle Arm. Have a person sit in the driver’s seat and hold the Accelerator Pedal down fully. Move the Throttle Arm on the Carburetor to its fully open position, thread the cable end through the Barrel Nut Assembly, then tighten the bolt of the Assembly.
What should the idle speed be on a VW Solex?
After the engine is fully warmed up, adjust the idle with a screwdriver at the large Air Bypass Screw on the left side of the Carburetor. Counter-Clockwise increases the idle, Clockwise decreases the idle. Idle speed should be set at approximately 850rpm (+-50rpm), a little higher for Auto-Stick Transmission Models. 16.
What are the parts of a Solex carburetor? Solex carburetor is a down draught type carburetor. It consists of the devices for starting, idling normal running and acceleration. These are described in brief as follows. The figure shows a starting device for Solex carburetor. It consists of a starter valve in the form of a…