What is maximum path in RIP?

Above you can see that RIP will use a maximum of 4 paths. If we want, we can change this: R1(config)#router rip R1(config-router)#maximum-paths ? < 1-32> Number of paths. On this router, we can choose anywhere between 1 and 32. The maximum number of paths depends on your IOS version.

What is the maximum number of paths equal load balancing can support?

Six different paths configured is the maximum number.

Does RIP load-balance?

RIP automatically performs load balancing using equal-cost routes. Notice that both routes have a metric of 1. In this case, it is a hop count. RIP cannot perform unequal-cost load balancing.

What is BGP maximum paths?

Number of Paths Limitation The number of paths supported are limited to 2 BGP multipaths.

Does OSPF support unequal load balancing?

RIP and OSPF both can do load-balancing but the paths have to be equal. unequal load-balancing! Even better it will share traffic in a proportional way, if you have a feasible successor that has a feasible distance which is 5 times worse than the successor then traffic will be shared in a 5:1 way.

Which command displays RIP routes?

debug IP rip command
Which command displays RIP routing updates? Explanation: The debug IP rip command is used to show the Internet Protocol (IP) Routing Information Protocol (RIP) updates being sent and received on the router.

What’s the maximum number of paths rip can load?

You have learned that RIP will load balance on all paths with same metric, the default setting (depending on your Cisco IOS version) is 4. You can change this with the maximum-paths command. The minimum is 1, which disables load balancing. The maximum value will depend on your IOS version.

How many equal cost paths does Cisco RIP support?

RIP can load balance between 4 equal cost paths by default. The older codes of Cisco IOS support load balancing across a maximum of 6 equal cost paths while the newer codes support load balancing across a maximum of 16 equal cost paths. You can change the default value of 4 using the maximum-paths number under the routing configuration mode.

How are hop counts measured in RIPv2 configuration?

Those costs are measured in hop counts or the number of routers to go through along a certain path. This makes it less effective in selecting the best path in the presence of this redundant topology. The one hop path across that slower link will be selected, whereas the three-hop path would be faster but would not be selected.

What is the configuration of RIP version 2?

Even though RIP version 2 is a classless protocol, its configuration follows a classful criteria and so the network you specify there is a major classful network number. So it becomes your job to look at the router’s interfaces, understand the network IDs attached or assigned to those interfaces, and then enable the protocol on those networks.

What is maximum path in RIP? Above you can see that RIP will use a maximum of 4 paths. If we want, we can change this: R1(config)#router rip R1(config-router)#maximum-paths ? < 1-32> Number of paths. On this router, we can choose anywhere between 1 and 32. The maximum number of paths depends on your IOS…