What is the stall speed of a Cessna 172?

Specifications

	1965 172F (Skyhawk)	1997-2007 172R (Skyhawk)
Stall Speed Clean	50 Knots	51 KCAS
Stall Speed Landing Configuration	43 Knots	47 KCAS
Climb Best Rate	645 FPM	720 FPM
Wing Loading	13.2 lbs./sq. ft.	14.1 lbs./sq. ft.

What is the purpose of power on stall?

OBJECTIVE: To develop the pilot’s ability to recognize an approaching stall by sound, sight, and feel; familiarize the pilot with the conditions that produce power-on stalls; and to develop the habit of taking prompt preventative or corrective action to recover from a stall.

What does a Power On stall simulate?

Practice in both power-on and power-off stalls is important because it simulates stall conditions that could occur during normal flight maneuvers. It is important for pilots to understand the possible flight scenarios in which a stall could occur.

How do you recover from a Cessna 172 spin?

PLACE AILERONS IN NEUTRAL POSITION. APPLY AND HOLD FULL RUDDER OPPOSITE TO THE DIRECTION OF ROTATION. JUST AFTER THE RUDDER REACHES THE STOP, MOVE THE CONTROL WHEEL BRISKLY FORWARD FAR ENOUGH TO BREAK THE STALL. Full down elevator may be required at aft center of gravity loadings to assure optimum recoveries.

How do you recover a stall on a Cessna 172?

To recover from a power-off stall scenario in a Cessna 172, execute the following sequence of procedures from the Pilot’s Operating Handbook (POH): At stall buffet, simultaneously reduce pitch, level the wings, add full power, carb heat off, right rudder pressure. Smoothly raise the pitch to climb altitude.

How do you recover from a power-on stall?

Pilots must recognize the lead-up to a power-on stall to avoid it, or recover from it. The good news is that the recovery procedure is stone simple: Fly coordinated, and reduce the angle of attack. The stall horn will be quiet, the airplane will stop buffeting and accelerate, and it will stop trying to turn.

Can you do spins in a 172?

The Cessna 172 is used a lot for training and is approved for spins when operated in the Utility Category. The later model 172s will spin, and are approved, but they just don’t spin as nicely as the old ones.

What is the top speed for a Cessna?

The Cessna Citation Excel has a maximum range (not including headwinds, high altitude, hot temperatures, or higher capacity) of 2,063 miles and a maximum speed of 498 mph.

What is the maximum gross weight of a Cessna 172?

The basic 172 appeared in November 1955 as the 1956 model and remained in production until replaced by the 172A in early 1960. It was equipped with a Continental O-300 145 hp (108 kW) six-cylinder, air-cooled engine and had a maximum gross weight of 2,200 lb (998 kg).

What is the stall speed of a Cessna Citation I?

Specifications (Cessna Citation I) Maximum speed: Mach 0.705 Cruise speed: 357 kn (411 mph, 661 km/h) at 35,000 ft (11,000 m) Stall speed: 82 kn (94 mph, 152 km/h) ( CAS) Range: 1,328 nmi (1,528 mi, 2,459 km) at 41,000 ft (12,000 m) (45 min reserves, 1,562 lb (709 kg) payload) Service ceiling: 41,000 ft (12,000 m) Rate of climb: 2,719 ft/min (13.81 m/s)

What is the NE of a Cessna 172?

Cessna started production on the 172 in 1956 , manufacturing more than 1,400 aircraft in the first year of production. The 172 evolved as Cessna responded to the flying public’s desire for a more modern, comfortable, and safer airplane.

What is the stall speed of a Cessna 172? Specifications 1965 172F (Skyhawk) 1997-2007 172R (Skyhawk) Stall Speed Clean 50 Knots 51 KCAS Stall Speed Landing Configuration 43 Knots 47 KCAS Climb Best Rate 645 FPM 720 FPM Wing Loading 13.2 lbs./sq. ft. 14.1 lbs./sq. ft. What is the purpose of power on stall? OBJECTIVE:…