What kind of fluid goes in a trim pump?

SAE 10W30 Automotive Oil A substitute for outboard tilt-trim oil is automotive oil with SAE 10W30 specification. For example, it is recommended that you use SAE 10W30 oil in older Mercruiser brand trim pumps.

What do you use for tilt and trim fluid?

I use Yamalube Performance Power Tilt and Trim Fluid because it’s non-foaming so you don’t get any air trapped in it, and it’s made to resist the extreme heat and high pressures that take place inside the hydraulic system.

Can you use power steering fluid for boat trim?

You will be fine. If there is any change in the speed of the the tabs, that will be short lived until the fluids gets all mixed together. Chances are you won’t notice any difference.

What oil do you use for trim Tabs?

Use any type of Automatic Transmission Fluid (ATF). Don’t worry about the exact brand or type – it will all work, and can even be mixed. To add fluid, remove the Lexan cover on the HPU, locate the “filler stack” in the left front corner of the reservoir.

How do you check trim fluid?

Re: How to check power trim fluid (OPTI) Try trimming it down on a piece of wood then loosen up the slotted screw on the port side with a 5/16 flathead screwdriver at least 3 turns then trim up about 20 seconds then down 20 seconds. Close off the bleed scred and check it out.

What weight is power trim fluid?

Amazon.com: Pennzoil 3382 Pennzoil Marine Power Trim and Tilt Fluid – 10 oz. : Automotive. In Stock.

How do you fill a trim tab reservoir?

With trim tabs completely retracted, fluid level should be about 2″ from bottom of reservoir (approximately 22 ounces). To refill, remove lexan cover and filler plug located at the front left hand corner of the reservoir. FILL WITH ANY TYPe AUToMATIC TRANSMISSIoN FLUID (ATF) oNLY. Brands or types of ATF can be mixed.

Where is the power trim fluid held in a MerCruiser?

Power trim fluid is held in a reservoir inside the power trim pump or in a separate plastic reservoir near the pump. Maintaining proper levels of fluid is necessary for the trim system to operate properly.

What kind of fluid do you use for a trim pump?

Super Tech Marine Power Trim and Tilt Fluid is specially formulated to deliver optimal pump and seal life. It is made with anti-foam and extreme pressure additives that work together to provide stability and shear resistance. This trim hydraulic fluid also inhibits rust.

Can you use tilt fluid in power trim?

How do you check power trim fluid level?

Check the fluid level using the fill mark on the side of the reservoir. Open a container of power trim fluid. Most containers have a long neck with a narrow spout, eliminating the need for a funnel. Pour power trim fluid into the opening until the level reaches the bottom of the threads on the fill screw opening or the full mark on the reservoir.

What kind of fluid goes in a trim pump? SAE 10W30 Automotive Oil A substitute for outboard tilt-trim oil is automotive oil with SAE 10W30 specification. For example, it is recommended that you use SAE 10W30 oil in older Mercruiser brand trim pumps. What do you use for tilt and trim fluid? I use Yamalube…