Why is my UPC WIFI not working?

Restart the modem by first switching it off with the on/off switch (see picture) and then switching it on again after about 30 seconds. Wait until the modem has completely restarted. This may take up to 15 minutes.

How do I reset my UPC router?

To do so, press the reset button on the back of your modem. The reset button is marked in green in the picture below. Keep the button pressed for more than 15 seconds. Your modem will be restarted.

Why is my router not connecting to the network?

There are a lot of possible reasons for why your internet isn’t working. Your router or modem may be out of date, your DNS cache or IP address may be experiencing a glitch, or your internet service provider could be experiencing outages in your area. The problem could be as simple as a faulty Ethernet cable.

How do I access my UPC router?

ADMIN AREA

Open the Internet browser and enter 192.168.0.1 in the address line.
Enter “Settings password” (see figure “Access data”)
Select “Advanced settings”
Select “Configure your wifi connection”
Enter name and/or password and click on “Adopt changes”

Why my Wi-Fi booster is not working?

This kind of issue can occur if the extender does not have the latest firmware. Process: Make sure the extender is connected to the power adapter provided and into a live power outlet. Make sure the extender is within the Wi-Fi range of the wireless router and client device is connected to the extenders network.

How do I reset my Wi-Fi booster?

We suggest that you to reset your Wi-Fi Booster:

Press for at least 10 seconds with a pencil or toothpick into the small hole on the back of the unit.
Release when all LEDs except Power and WPS go out. The WPS indicator light will go out after a few seconds.
Unplug your Wi-Fi Booster.

How do I connect to my UPC Wi-Fi?

Open the list of available Wi-Fi networks on your computer. Select a “UPC Wi-Free” Wi-Fi network and enter your login data for Wi-Free when prompted. This is how you connect to the hotspot.

How to troubleshoot a problem with a Cisco router?

Steps to Troubleshoot 1 Verify cable connectivity. 2 Verify that the power supply is on. 3 Verify the router LED status. If all LEDs are down, it is most likely an issue with the power supply of the router.

How to troubleshoot Cisco 2600 and 3700 routers?

For complete installation instructions, refer to AIM Installation Quick Start Guide: Cisco 2600, 3600, and 3700 Series. In order to verify that the card is now correctly detected, issue the show crypto engine config command. The crypto engine type line will read hardware, and the configuration field will contain valid hexadecimal numbers.

Is there a problem with my Cisco 801 router?

Contact your Cisco reseller. Table 3-2 lists problems that could occur after the router has power for the first time. No link to an Ethernet device. (On Cisco 801, Cisco 802, and 802 IDSL routers, the LINK LED on the back panel is off.

Why are some modules not hot swappable on a Cisco router?

Some modules are not hot swappable; reload the router after you install the module. If the module’s hardware information is shown in the show diag but you are not able to see the module interfaces in the show run or show IP interface brief output, check the hardware installation documentation.

Why is my UPC WIFI not working? Restart the modem by first switching it off with the on/off switch (see picture) and then switching it on again after about 30 seconds. Wait until the modem has completely restarted. This may take up to 15 minutes. How do I reset my UPC router? To do so,…