How do I reset my passlock?

How do I reset my passlock?

How to Reset the Passlock System on GM Cars

1. Insert your key in the starter, start you car as you usually would and let it stall. Keep the key in the “On” position.
2. Wait until the “Theft Sys” light on your dashboard stays on without blinking. This will take approximately 10 to 15 minutes.

How do I fix my passlock GM?

How to Fix Passlock for Chevy Vehicles. A temporary fix is to leave your key in the ignition, at the “auxiliary” position for about 10-15 minutes until the security light shuts off. When the light shuts off you can try to start the engine again. Rinse, repeat, and cry.

How can I bypass pass theft deterrent system?

Thankfully this is an easy fix.

1. Leave the ignition key turned to the “On” position after the vehicle has stalled and will not start.
2. Look at the dashboard and locate the theft system light.
3. Turn the ignition to the “Off” position to disable the PassLock system, and wait for 20 seconds for the system to reset.

What is passlock?

The PassLock system was designed to prevent vehicle theft by disabling fuel to the engine if attempts are made to start the vehicle without the correct bitted key. PASSLock increased the level of security while retaining the ease of service and costs offered by standard ignition lock systems.

Where is passlock sensor located?

The Passlock III system uses a transponder located under the plastic covering of the key. In most cases, these keys are stamped “PK3” on the metal blade near the plastic covering.

Does passlock disable fuel pump?

The factory Passlock anti-theft system immobilizes our cars by simply disabling the fuel pump from running. No fuel pressure = no car stealing. Check your car this way; use the remote keyfob to LOCK the car and observe the speedo or tach for the security indicator to start flashing or turn on.

How do you bypass the anti-theft system on GM passlock 2?

PASSLOCK-II bypass procedure 1: Locate two wires, which are THIN and are in the main ignition harness.. Orange/Black (or Black) and Yellow. 2: Cut the Yellow wire, and strip back some of the insulation from the Orange/Black (Or Black) wires. 3: Turn the ignition to the “Run” position ( don’t crank the starter).

Can you disable PassLock?

The Passlock system on a Vehicles is the anti-theft system. The Passlock system uses a recognition transponder in the ignition tumbler and a computer chip in the ignition key. While you cannot remove the Passlock system, you can disable it by tricking it into thinking the Vehicles had a malfunction.

How do I reset my passlock? How to Reset the Passlock System on GM Cars Insert your key in the starter, start you car as you usually would and let it stall. Keep the key in the “On” position. Wait until the “Theft Sys” light on your dashboard stays on without blinking. This will take…